Today we will learn about forging defects types, causes and its remedies.
Defects are common in every manufacturing process like casting includes casting defects, welding includes welding defects, same as forging consist some defects
which are due to both process and human limitations. Forging gives better mechanical
properties among all manufacturing process but it also includes some common
defects which are described below.
Forging Defects: Types, Causes and Remedies
1.) Unfilled Section:
As the name implies in this type of defect some of the
forging section remain unfilled. This is
due to poor design of die or poor forging technic. This is also due to less raw
material or poor heating.
This defect can be removed by proper die design, proper
availability of raw material and proper heating.
2.) Cold Shut:
Cold shut includes small cracks at corners. These defects
occur due to improper design of forging die. It is also due to sharp corner, and
excessive chilling in forge product.
The fillet radius of the die should be increase to remove
these defects.
3.) Scale Pits:
Scale pits are due to improper cleaning of forged surface.
This defect generally associated with forging in open environment. It is
irregular deputations on the surface of forging.
It can be removed by proper cleaning of forged surface.
4.) Die Shift:
Die shift is caused by misalignment of upper die and lower
die. When both these dies are not properly aligned the forged product does not
get proper dimensions.
This defect can be removed by proper alignment. It can be
done by provide half notch on upper die and half on lower die so at the time of
alignment, both these notches will matched.
5.) Flakes:
These are internal cracks occur due to improper cooling of
forge product. When the forge product cooled quickly, these cracks generally
occur which can reduced the strength of forge product.
This defect can be removed by proper cooling.
6.) Improper Grain Growth:
This defect occurs due to improper flow of metal in casting
which changes predefine grain structure of product.
It can be removed by proper
die design
7.) Incomplete Forging Penetration:
This defect arises due to incomplete forging. it is due to
light or rapid hammer blow.
This defect can be removed by proper control on forging
press.
8.) Surface Cracking:
Surface cracking occurs due to exercise working on surfaces
at low temperature. In this defect, So many cracks arise on work piece.
This defect can be removed by proper control on working temperature.
9.) Residual Stresses in Forging:
This defect occurs due to improper cooling of forged part.
Too much rapid cooling is main causes of this type of defects.
This can be removed by slow cooling of forged part.
These are all main types of forging defects. If you have any
query regarding this article, ask by commenting. If you like this article,
don’t forget to share it on social networks. Subscribe our website for more
interesting articles.F